DTC Information: DTC Detecting Condition

Item		Detecting Condition	Possible Cause
DTC Strategy		Check the WSS signal	Poor connector connection Open or short in signal circuit of WSS rear-LH Faulty WSS rear-LH
Enable Condition		Ignition "ON" Auxiliary battery normal voltage (7 to 17V)
Threshold Value		A failure is detected when the current of WSS is out of specified range of 3.6 to 66 mA longer than 140 ms
Warning Lamp	Only One Wheel Failure	RBS, ABS, ESP, DBC, AVH
	Two Or More Wheels Failure	RBS, EBD, ABS, ESP, DBC, AVH
	4 wheels failure	EBD, ABS, ESP, IEB, RBS, DBC, AVH, EPB, CHECK BRAKE
Detecting Time		140 ms
Disable Condition		Ignition "OFF" and then "ON"