DTC Information: DTC Detecting Condition

Item		Detecting Condition	Possible Cause
DTC Strategy		Check the WSS signal	Poor connector connection Open or short in signal circuit of WSS front-LH Faulty WSS front-LH
Enable Condition		Ignition "ON" Auxiliary battery normal voltage (7 to 17V)
Threshold Value		If the WSS current is out of the specific range of 3.6 mA to 66 mA longer than 140 ms If the leakage current of WSS is greater than specific current longer than 140 ms
Warning Lamp	Only One Wheel Failure	RBS, ABS, ESP, DBC, AVH
	Two Or More Wheels Failure	RBS, EBD, ABS, ESP, DBC, AVH
	4 Wheels Failure	EBD, ABS, ESP, IEB, RBS, DBC, AVH, EPB, CHECK BRAKE
Detecting Time		140 ms
Disable Condition		Current is normal after the ignition switch turns off and then on