Repair Procedures: Removal

NOTE:

When working on the high voltage system, the work should be performed by technicians who have completed the relevant training. A lack of understanding of the high voltage system can lead to serious accidents due to electric shock or short circuit.
When working on the high voltage system or related components, be sure to observe and be aware of the "Safety Precautions, Cautions and Warnings". If not, it may cause serious accidents due to electric shock or short circuit.
When working on the high voltage system, make sure to check the Personal Protective Equipment (PPE) and high voltage shut-off procedure.

Remove the front bumper assembly.
(Refer to Front bumper - "FRONT BUMPER ASSEMBLY ")
Disconnect the smart key antenna connector (A).

Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the Virtual Engine Sound System (VESS) connector (A).

Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the front radar connector (A).

Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the ambient temperature sensor connector (A).

Courtesy of KIA MOTORS AMERICA, INC.
Remove the front bumper beam assembly (A) by removing the mounting bolts and nuts.
Tightening torque

21.6 - 26.5 N.m (2.2 - 2.7 Kgf.m, 15.9 - 19.5 lb.ft)

Courtesy of KIA MOTORS AMERICA, INC.
Remove the Virtual Engine Sound System (VESS) (A) by removing the mounting bolts.

Courtesy of KIA MOTORS AMERICA, INC.
Remove the smart key (A) by removing the mounting nuts.

Courtesy of KIA MOTORS AMERICA, INC.
Remove the Front Radar (A) by removing the mounting nuts.

Courtesy of KIA MOTORS AMERICA, INC.