Repair Procedures: Installation
WARNING: This page is about a different variant/trim than selected.
- Install in the reverse order of removal.NOTE:
- Check the following procedures before installing the gear actuator assembly.
- Check that the gear actuator is placed in the "neutral" state.
- Check the assembled state of the O-rings (A).
- Apply gear oil to the surface of O-rings (A).
- Check the assembled state of the dowel pins (A).
- Check the assembled state of the air breather (A).
- Perform the DCT learning procedure using the KDS after replacing the gear actuator assembly.NOTE:
- Perform the DCT learning procedure only if reinstalling the transmission after replacing the gear actuator from the removed transmission. (DCT learning is not required if actuator is replaced without removing the transmission.)
- Before performing the DCT learning procedure using KDS, perform the learning process after leaving for 5 minutes in the idle state. Because it may cause a problem to operation of wear compensation device when entering the DCT learning function at battery low voltage condition.
- When performing the DCT learning function, Perform the DCT learning function twice for ensure accuracy and reliability of the clutch touch point.
- When the ignition is turned off after completing the 2 steps of the DCT learning procedure, the operation of wear compensation device will be performed. It takes up to 6 minutes for the operation of the wear compensation device to be completed, during which time it should not be started engine.
- The engine must be started after at least 6 minutes to ensure that the wear compensation device is fully operated. (keep the engine off for at least 6 minutes)
- If the engine is started while the wear compensation device is operating, sufficient operation of the wear compensation device is not possible, so the excessive operation of the wear compensation device may occur in the next engine starting cycle.