Repair Procedures: Installation
WARNING: This page is about a different variant/trim than selected.
- Install in the reverse order of removal.NOTE:
- If needed, perform clutch actuator clutch wear compensation reset.
(Refer to Clutch Actuator & Assembly - "ADJUSTMENT ")
- Check the assembled state of the dowel pins (A) before installing the clutch actuator & TCM assembly.
- If needed, perform clutch actuator clutch wear compensation reset.
- Perform the DCT learning procedure using the KDS after replacing the clutch actuator & TCM assembly.NOTE:
- Before performing the DCT learning procedure using KDS, perform the learning process after leaving for 5 minutes in the idle state. Because there may be a problem with operation of wear compensation device when entering the DCT learning function with battery low voltage condition.
- When performing the DCT learning function, Perform the DCT learning function twice for ensure accuracy and reliability of the clutch touch point.
- When the ignition is turned off after completing the 2 steps of the DCT learning procedure, the operation of wear compensation device will be performed. It takes up to 6 minutes for the operation of the wear compensation device to be completed, during which time it should not be started engine.
- The engine must be started after at least 6 minutes to ensure that the wear compensation device is fully operated. (keep the engine off for at least 6 minutes)
- If the engine is started while the wear compensation device is operating, sufficient operation of the wear compensation device is not possible, so the excessive operation of the wear compensation device may occur in the next engine starting cycle.