LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2023 >> EV6 Light >> Repair and Diagnosis >> Hybrid/Electric Powertrain >> Cooling Systems >> RESERVOIR TANK (2WD / 70kW+160kW AWD) >> Removal And Installation - (2WD) >> Installation

Removal And Installation - (2WD): Installation

  1. Install in the reverse order of removal.
    NOTE: Make sure the quick connector is installed securely after installing coolant hose.
    [Type A] 
    • Make sure the quick connector (A) is installed securely.
      G15815708Courtesy of KIA MOTORS AMERICA, INC.

      [Type B] 

    • Make sure the quick connector and quick connector clamp is installed securely.
    • Make sure that the quick connector protrusion (A) fits into the groove (B).
      G15815709Courtesy of KIA MOTORS AMERICA, INC.
  2. Fill with coolant.

    (Refer to Electric Vehicle Cooling System - " COOLANT  ") 

    NOTE: Perform "Electric Water Pump Control" to air bleeding using KDS when filling with coolant.
scientia non olet · About LEMON Manuals