Component Inspection

Inspection Condition	Inspection Procedure	Reference
Ignition "OFF".	Check the brake pads for wear and fade. Check the brake disc for damage and deformation. Check the brake tubes for cracks, crimps and corrosion. Check brake hose mounting bracket for crack or deformation.	-

Good

Fault is intermittent caused by poor contact in the sensor's or IEBU's connector or was repaired and IEBU memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
Repair or replace as necessary and go to "Verification of Repair " procedure.

No Good

Carefully re-do this troubleshooting guide steps.
If no problems were found with the circuits or connectors, replace the IEBU and go to "Verification of Repair " procedure.
* In case of replacing IEBU, perform "Vehicle S/W Management" procedure as Component Inspection of C110101. Refer to COMPONENT INSPECTION