■ ESC Variant Coding

Inspection Condition	Inspection Procedure	Reference
Ignition "ON".	Connect KDS to "Data Link Connector (DLC)". Perform "ESC Variant Coding" in "Vehicle S/W management" with KDS.	Fig.1 to 5

G14868031

Courtesy of KIA MOTORS AMERICA, INC.

G14868032

Courtesy of KIA MOTORS AMERICA, INC.

G14868033

Courtesy of KIA MOTORS AMERICA, INC.

G14868034

Courtesy of KIA MOTORS AMERICA, INC.

G14868035

Courtesy of KIA MOTORS AMERICA, INC.

Good

Fault is intermittent caused by poor contact in the sensor's or IEBU's connector or was repaired and IEBU memory was not cleared. Therefore check terminal of battery, all connectors and connections for looseness, bending, corrosion, contamination, deterioration, and/or damage.
Repair or replace as necessary and then go to "Verification of Repair " procedure.

No Good

Carefully re-do this troubleshooting guide steps.
If no problems were found with the circuits or connectors, replace the IEBU and go to "Verification of Repair " procedure.
* In case of replacing IEBU, perform "Vehicle S/W Management" procedure as component inspection of C110101. Refer to COMPONENT INSPECTION