DTC Information: DTC Detecting Condition

Item	Detecting Condition	Possible Cause
DTC Strategy	Check current	Short to ground in DSAB harness Poor connection between shorting bar and release pin Faulty DSAB Check SRSCM CAUTION: * Do not replace the SRSCM due to a history fault
Enable Conditions	Ignition "ON" or EV "ON"
Threshold Value	DSAB leak resistance is less than 1kΩ Internal measured current value above 520uA or below 380uA (measured reference voltage = 2.5V)
Diagnostic Time	4.5s
Recovery Time	9s
MIL ON Condition	MIL "ON"