| DTC Strategy |
- Monitor voltage, current, temperature
|
- Pressure sensor or pedal travel sensor out of zero point
- Air bleeding is not sufficiently performed
- Faulty IEBU
|
| Enable Condition |
- Normal battery voltage (8 to 16.5V)
- Ignition "ON"
|
| Threshold Value |
Case 1 |
- When the pedal simulator pressure is abnormally generated compared to the pedal input
|
| Case 2 |
- When pedal simulator pressure is measured as same as circuit pressure
|
| Case 3 |
- When the circuit pressure is not normally reduced during decompression control
|
| Case 4 |
- When a specific valve failure is confirmed as a result of self-test after detecting a circuit leak failure
|
| Detecting Time |
Case 1 |
|
| Case 2 |
|
| Case 3 |
|
| Case 4 |
|
| Warning Lamp |
|
| Disable Condition |
- If valve and valve relay initial active test are normal after ignition off/on
|