DTC Information: DTC Detecting Condition

Item		Detecting Condition	Possible Cause
DTC Strategy		Monitor voltage, current, temperature	Faulty auxiliary battery Fuse open and faulty wire harness Faulty IEBU
Enable Condition		Normal battery voltage (8 to 16.5V) Ignition "ON"
Threshold Value	Case 1	If valve power is less than (2.0±0.2)V for 60ms when valve relay is on and valve is off If any of the following conditions are satisfied for 60ms when valve relay is on and valve power is on Valve current is greater than (8.5±2.5)A Temperature of the valve driver is greater than 195±20°C (383±68°F) If over than 3mA of leakage current of valve circuit is detected for 60ms
	Case 2	If valve voltage is less than 76% of Valve Relay Voltage for 60ms when valve is OFF If valve voltage is bigger than 30% of Valve Relay Voltage for 60ms when valve power is ON If valve control output and valve feedback status is not matched for 60ms
	Case 2	Check the fault of valve coil and valve electrical line with operating ABS/CBS valve sequentially In the progress, if it is determined to be a failure, it operates up to 5 additional times and then determined to be a failure more than 3 times, it is treated as a fault * Fail Condition (ABS Valve): Inactivated Valve Voltage lower than 2.0±0.2V Activated Valve Current greater than 8.5±2.5A * Fail Condition (CBS Valve): Inactivated Valve Solenoid Valve Voltage lower than 76% of Valve Relay Voltage Activated Valve Solenoid Valve Voltage greater than 30% of Valve Relay Voltage
Warning Lamp		EBD, ABS, ESP, DBC, AVH
Disable Condition		If valve and valve relay initial active test are normal after ignition off/on