Description & Operation: Description: Function
- High speed CAN communication (C-CAN)
- Custom Function: car seats linked to getting on/off motion, Welcome Light
- LDW: Lane Departure Warning
- LKA: Lene Keeping Assist
- PA: Parking Assist
- PDW: Parking Distance Warning
- Low speed CAN communication (M-CAN)
- AV: Audio/Video Multimedia information Display
- TBT: Turn By Turn Navigation Information Display
- Various source control
Various alarms and sound effects are issued through the external speakers connected to the instrument cluster.
Sound Description and function (CAN data receiver) Welcome Welcome (Key out and door open/closed state checked by IBU Goodbye Goodbye (Cluster) Door Open warning Key reminder warning (IBU), Vehicle speed is 5 km/h or below & IGN switch is ACC or IGN or engine start & when vehicle speed is below 5 km/h or when the driver side door is opened Seat belt warning Driver seat belt warning (IBU) PDW System warning PDW sensor fault warning (IBU) Gear R PDW warning when shift gear R (IBU and PA) Parking Brake Parking brake warning (IBU) Start button SSB button warning (IBU) Rheostat light information Rheostat warning when select the max or min degree (Cluster) Smart Key departure Smart key out warning (IBU) Smart Cruise Change from the conventional cruise to the smart cruise (SCC) Smart cruise driving information Smart cruise function cancel (SCC) Conventional cruise Change from the smart cruise to the conventional cruise (SCC) Turn signal lamp (Tick) Turn signal lamp warning (IBU) Turn signal lamp (Tock) Turn signal lamp warning (IBU) Smart key battery low voltage Warning when driver push the SSB button with low voltage battery smart key (IBU) EPB warning Warning when change from Auto Hold to EPB lock (EPB) Coolant temperature alarm When the engine temperature is over 120°C (EMS) - User Setting Mode (USM)
Setting can be changed by using the optic switch menu, and CW, CCW, OK buttons (or the UP, Down, Left, Right and OK button of the generic switch). There are total of 24 items (for example, In/Out Seat Synchronization, In/Out Steering Wheel Synchronization, Auto Door Lock, Auto Door Lock Deactivate, Head Lamp Escort, Welcome Light, Welcome Sound, Triple Turn Signal, Average Fuel Consumption Auto Reset, HUD Height Adjustment, Brightness, and Content Setup) that can be set and customized. The signal flow during setting is as follows.
- USM settings are set, they are transmitted to IBU.
- IBU transmits the settings via B-CAN to the relevant modules.
- The module completes setting and transmits the modified setting to IBU.
- IBU transmits the final settings via C-CAN to the cluster.
Information
The cluster communicates directly with C-CAN units.