LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2021 >> Sorento SX, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Fuel Delivery System - 2.5L (VIN C) (Except HEV)) >> Fuel Pump And Tube Assembly >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the fuel pump module.

    (Refer to Fuel Delivery System - "FUEL PUMP MODULE ")

  2. Disconnect the fuel pump motor connector (A) and fuel sender connector (B).
    G13661222Courtesy of KIA MOTORS AMERICA, INC.
  3. Remove the fuel feed tube quick-connector (B) after removing the clip (A).
    G13661223Courtesy of KIA MOTORS AMERICA, INC.
  4. Remove the fuel sender assembly (A) after pushing the hooks in the direction of the arrows.
    G13661224Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the stopper (A).
    G13661225Courtesy of KIA MOTORS AMERICA, INC.
  6. Remove the fuel pump plate & bracket (A).
    G13661226Courtesy of KIA MOTORS AMERICA, INC.
  7. Remove the reserve cup (A) after pulling the hooks in the direction of the arrows.
    G13661227Courtesy of KIA MOTORS AMERICA, INC.
  8. Remove the pump filter (A) after pulling the hooks in the direction of the arrows.
    G13661228Courtesy of KIA MOTORS AMERICA, INC.
  9. Remove the wiring from the fuel filter after disconnecting the fuel pump connector (A) and ground (B).
    G13661229Courtesy of KIA MOTORS AMERICA, INC.
  10. Remove the O-ring (B) and spacer (C) after removing the fuel pump & tube (A).
    G13661230Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About LEMON Manuals