DTC Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
|
- Poor connector connection
- Short to ITM circuit
- ITM
|
| Enable Conditions |
- Less than 10% of deceleration fuel cut-off time
- Less than 60% of low load state (vehicle speed less than 20km/h (12.43MPH))
- Less than 15% of high speed state (vehicle speed more than 90km/h (55.92MPH))
- Less than 50% of low speed (engine load less than 8.0 to 15.0%))
- Coolant temperature should not drop much at high engine speed
- High engine speed standard (more than 4500RPM)
- High engine speed for more than 40s
- Engine coolant temperature decrease is more than 2°C (35.6°F) at high engine speed
- Engine coolant temperature at startup is more than -10°C (14°F)
- Intake temperature is more than -6°C (21.2°F) at the start
- Ambient temperature is more than -8°C (17.6°F)
- No relevant failure
|
| Threshold Value |
- When the measured coolant temperature is below 73.9°C (165°F) while the coolant model temperature is above 85°C (185°F)
|
| Diagnostic Time |
- 10 to 30 minutes (depending on coolant temperature and operating conditions at startup)
|
| MIL ON Condition |
|