Repair Procedures: Replacement

NOTE:

When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
Put on gloves to prevent hand injuries.
Take care not to bend or scratch the trim and panels.

Disconnect the negative (-) battery terminal.
Remove the tailgate upper trim (A) by using a flat-head screwdriver or remover.

Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the high mounted stop lamp connector (A).

Courtesy of KIA MOTORS AMERICA, INC.
Remove the rear spoiler cap (A).

Courtesy of KIA MOTORS AMERICA, INC.
Remove the rear spoiler mounting nuts.
Tightening torque:

2.9 - 4.9 N.m (0.3 - 0.5 kgf.m, 2.2 - 3.6 lb.ft)

Courtesy of KIA MOTORS AMERICA, INC.
Remove the rear spoiler (A).

Courtesy of KIA MOTORS AMERICA, INC.
Install in the reverse order of removal.
Information
- Make sure the connector is connected properly.
- Replace any damaged clips.