Verification Of Repair

After a repair, it is essential to verify that the fault has been corrected.

1. Connect KDS to Data Link Connector (DLC), and monitor "Diagnostic Trouble Codes (DTC)".
2. Clear all DTCs in the system with KDS.
3. Operate system or vehicle within "DTC detecting condition" in "DTC Detecting Condition chart".
4. Monitor "Diagnostic Trouble Codes (DTC)" with KDS and verify that any DTC is stored.
5. Verify that the DTC is cleared and system operates correctly.

   * Do not replace SRSCM if there is no DTC after clearing the fault code.

   Good 

   • Problem is corrected and the system operation performs to specification at this time.

   No Good 

   • Go to applicable troubleshooting procedure.