Component Inspection

Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Engine "ON".	SRSCM connector	28 (ON/START Input)	Chassis ground	-	B+
Ignition "OFF". Disconnect the electrical connector(s) from the concerned component.	SRSCM connector	10 (Memory power)	Chassis ground	-	B+
Ignition "OFF". Disconnect the battery (-) terminal cable from the battery, and wait at least for five minutes. Disconnect the electrical connector(s) from the concerned component.	SRSCM connector	40 (ground)	Chassis ground	-	Approx. below 1Ω

Good

If no problems were found with the circuits or connectors, replace the SRSCM and go to "VERIFICATION OF REPAIR " procedure.

No Good