Circuit Inspection

WARNING: This page is about a different variant/trim than selected.

G13688806

Courtesy of KIA MOTORS AMERICA, INC.

Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Ignition "OFF". Disconnect the electrical connector(s) from the concerned component. Ignition "ON".	TCU	6 (power)	Chassis ground	-	B+
Ignition "OFF". Disconnect the electrical connector(s) from the concerned component.	TCU	2, 3 (ground)	Chassis ground	-	Approx. below 1Ω
Ignition "OFF". Disconnect the electrical connector(s) from the concerned component. Ignition "ON".	TCU	2 (input speed sensor power)	Chassis ground	-	Approx. 9V (reference Fig.1)
Ignition "OFF". Disconnect the electrical connector(s) from the concerned component. Ignition "ON".	TCU	1 (input speed sensor signal)	Chassis ground	-	Approx. 0V (reference Fig.1)

G13688807

Courtesy of KIA MOTORS AMERICA, INC.

Good

This fault is a temporary fault caused by failure to clear the fault code or by poor contact with the connector. Overall, check connectors for slackness, poor contact, bending, corrosion, contamination, deformation or damage. If the problem continues, replace the DCT assembly then go to "TCU Neutralization" and "Air bleeding" of S/W management and perform the "VERIFICATION OF REPAIR " procedure.

No Good

After repair or replacement if necessary, go to "VERIFICATION OF REPAIR " procedure.
After checking the circuit for open circuits or short circuits and repairing them, go to "VERIFICATION OF REPAIR " procedure.