Inspection Procedure
WARNING: This page is about a different variant/trim than selected.
- Check fuses and relays.
- Check battery terminals and charge status.
- Inspect following items.
- Damages on wiring harness and terminals: Inspect the open in wiring, deterioration and contact resistance, oxidation, deformation on terminals.
- Connection condition of connector: Inspect the damages on locking device, broken away terminals, and connection condition of terminals and wirings. Inspect the connection condition between male pins and female pins by disconnecting the connector. Once the inspection is complete, properly reconnect the pins.
Good
Go to "COMPONENT INSPECTION " procedure.
No Good
Repair as necessary and then go to "VERIFICATION OF REPAIR " procedure.