Circuit Inspection
| Module Circuit Inspection | |||||
|---|---|---|---|---|---|
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
| Connector | Terminal | Connector | Terminal | ||
|
SRSCM connector | 10 (Memory power) | Chassis ground | - | B+ |
| SRSCM connector | 40 (ground) | Chassis ground | - | Approx. below 1Ω | |
|
SRSCM connector | 28 (ON/START Input) | Chassis ground | - | B+ |
Good
- Go to next procedure.
No Good
- Repair open or short in circuit and then go to "VERIFICATION OF REPAIR " procedure.
| CAN communication circuit Inspection (W/O EPB) | |||||
|---|---|---|---|---|---|
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
| Connector | Terminal | Connector | Terminal | ||
|
HECU connector | 4 (C-CAN high) | Chassis ground | - | Fig.1 |
| HECU connector | 5 (C-CAN low) | Chassis ground | - | ||
|
HECU connector | 4 (C-CAN high) | SRSCM connector | 27 (C-CAN high) | Approx. below 1Ω |
| HECU connector | 5 (C-CAN low) | SRSCM connector | 26 (C-CAN low) | Approx. below 1Ω | |
|
HECU connector | 4 (C-CAN high) | HECU connector | 5 (C-CAN low) | Approx. 60Ω |
| ICU (component side) | 20 (C-CAN high) | ICU (component side) | 19 (C-CAN low) | Approx. 120Ω | |
| SRSCM (component side) | 27 (C-CAN high) | SRSCM (component side) | 26 (C-CAN low) | Approx. 120Ω | |
| CAN communication circuit Inspection (With EPB) | |||||
|---|---|---|---|---|---|
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
| Connector | Terminal | Connector | Terminal | ||
|
HECU connector | 19 (C-CAN high) | Chassis ground | - | Fig.1 |
| HECU connector | 20 (C-CAN low) | Chassis ground | - | ||
|
HECU connector | 19 (C-CAN high) | SRSCM connector | 27 (C-CAN high) | Approx. below 1Ω |
| HECU connector | 20 (C-CAN low) | SRSCM connector | 26 (C-CAN low) | Approx. below 1Ω | |
|
HECU connector | 19 (C-CAN high) | HECU connector | 20 (C-CAN low) | Approx. 60Ω |
| ICU (component side) | 20 (C-CAN high) | ICU (component side) | 19 (C-CAN low) | Approx. 120Ω | |
| SRSCM (component side) | 27 (C-CAN high) | SRSCM (component side) | 26 (C-CAN low) | Approx. 120Ω | |
Good
- Carefully re-do this troubleshooting guide steps.
- If no problems were found with the circuits or connectors, replace the SRSCM and go to "VERIFICATION OF REPAIR " procedure.
No Good
- Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
- Repair open or short in circuit and then go to "VERIFICATION OF REPAIR " procedure.