Circuit Inspection

G00610996

Courtesy of KIA MOTORS AMERICA, INC.

G00610997

Courtesy of KIA MOTORS AMERICA, INC.

HECU W/O EPB

Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Ignition "OFF". Disconnect the electrical connector(s) from the concerned component. Ignition "ON".	BBVPS connector	3 (power)	Chassis ground	-	5V
	BBVPS connector	1 (signal)	Chassis ground	-	0V
Ignition "OFF". Disconnect the electrical connector(s) from the concerned component.	BBVPS connector	3 (power)	HECU connector	28 (power)	Approx below 1Ω
	BBVPS connector	1 (signal)	HECU connector	27 (signal)	Approx below 1Ω
	BBVPS connector	2 (ground)	Chassis ground	-	Approx below 1Ω

HECU With EPB

Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Ignition "OFF". Disconnect the electrical connector(s) from the concerned component. Ignition "ON".	BBVPS connector	3 (power)	Chassis ground	-	5V
	BBVPS connector	1 (signal)	Chassis ground	-	0V
Ignition "OFF". Disconnect the electrical connector(s) from the concerned component.	BBVPS connector	3 (power)	HECU connector	11 (power)	Approx below 1Ω
	BBVPS connector	1 (signal)	HECU connector	10 (signal)	Approx below 1Ω
	BBVPS connector	2 (ground)	Chassis ground	-	Approx below 1Ω

Good

Carefully re-do the troubleshooting guide steps.
If no problems were found with the circuits or connectors, replace the BBVPS and go to "Verification Of Repair " procedure.

No Good

Repair open or short in circuit and then go to "Verification Of Repair " procedure.