Component Inspection
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
BLS (component side) | 4 (Memory power) | BLS (component side) | 5 (stop lamp signal) | ∞ (infinity)Ω |
| BLS (component side) | 1 (ON/START Input) | BLS (component side) | 2 (stop signal) | Approx. below 1Ω | |
|
BLS (component side) | 4 (Memory power) | BLS (component side) | 5 (stop lamp signal) | Approx. below 1Ω |
| BLS (component side) | 1 (ON/START Input) | BLS (component side) | 2 (stop signal) | ∞ (infinity)Ω | |
Good
- Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
- Repair or replace as necessary and then go to "VERIFICATION OF REPAIR " procedure.
No Good
- Carefully re-do this troubleshooting guide steps.
- If no problems were found with the circuits or connectors, replace the BLS and go to "VERIFICATION OF REPAIR " procedure.