| DTC Strategy |
- Check the amount of clutch slip
|
- Clutch mechanical fault
- Clutch actuator stuck off
|
| Enable Condition |
- The difference between clutch target pressure and actual pressure is less than 3 bar
- Clutch actual pressure above 10bar
- Odd number gear engagement
- Battery voltage above 10V
- Engine speed above 500 RPM
- Line pressure over 30bar
|
| Threshold Value |
- Clutch target torque greater than 100 Nm and clutch actual torque less than 20 Nm
- If the difference between engine revs and input shaft speed revs is greater than 1000 RPM
|
| Diagnostic Time |
|
| MIL |
|