Circuit Inspection
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
Chassis ground | 5 (power) | Chassis ground | - | Approx. 5V |
|
Chassis ground | 6 (ground) | Chassis ground | - | Approx. 0V |
|
Chassis ground | 7 (signal 1) | Chassis ground | - | Approx. 0V |
|
Chassis ground | 8 (signal 2) | Chassis ground | - | Approx. 0V |
Good
- Go to "COMPONENT INSPECTION " procedure.
No Good
- After repair or replacement if necessary, go to "VERIFICATION OF REPAIR " procedure.
- Check the module circuit for open circuits or short circuits after repair, then go to "VERIFICATION OF REPAIR " procedure.