Component Inspection

Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Ignition "OFF". Disconnect battery (-) cable. Disconnect the electrical connector(s) from the concerned component.	Position sensor connector	5 (power)	Position sensor connector	7 (S1)	Fig.1
	Position sensor connector	8 (S2)	Position sensor connector	6 (ground)	Fig.1
Ignition "OFF". Disconnect battery (-) cable. Disconnect the electrical connector(s) from the concerned component.	Position sensor connector	5 (power)	Position sensor connector	7 (S1)	Fig.2
	Position sensor connector	8 (S2)	Position sensor connector	6 (ground)	Fig.2
Ignition "OFF". Disconnect battery (-) cable. Disconnect the electrical connector(s) from the concerned component.	Position sensor connector	5 (power)	Position sensor connector	7 (S1)	Fig.3
	Position sensor connector	8 (S2)	Position sensor connector	6 (ground)	Fig.3
Ignition "OFF". Disconnect battery (-) cable. Disconnect the electrical connector(s) from the concerned component.	Position sensor connector	5 (power)	Position sensor connector	7 (S1)	Fig.4
	Position sensor connector	8 (S2)	Position sensor connector	6 (ground)	Fig.4

G13688843

Courtesy of KIA MOTORS AMERICA, INC.

G13688844

Courtesy of KIA MOTORS AMERICA, INC.

G13688845

Courtesy of KIA MOTORS AMERICA, INC.

G13688846

Courtesy of KIA MOTORS AMERICA, INC.

Good

Re-do the appropriate diagnostic guide.
Check shift cable alignment for abnormalities. In the event of a problem, after arranging the cable, go to "VERIFICATION OF REPAIR " procedure.
If the problem continues, replace the TCU, go to "VERIFICATION OF REPAIR " procedure.

No Good

Re-do the appropriate diagnostic guide.
If wiring and connectors are intact and symptoms persist, and after replacing the problematic position sensor, go to "VERIFICATION OF REPAIR " procedure.