Circuit Inspection

G13666206

Courtesy of KIA MOTORS AMERICA, INC.

Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Ignition "OFF". Disconnect the battery (-) cable and wait at least for five minutes. Disconnect the electrical connector(s) from the concerned component.	P-SIS connector	1 (high)	SRSCM connector	46 (high)	Approx. below 1Ω
	P-SIS connector	2 (low)	SRSCM connector	45 (low)	Approx. below 1Ω
	P-SIS connector	1 (high)	Chassis ground	-	∞ (infinity)Ω
	P-SIS connector	2 (low)	Chassis ground	-	∞ (infinity)Ω
Connect the SRSCM main connector. Connect the battery (-) terminal cable to the battery. Ignition "ON".	P-SIS connector	1 (high)	Chassis ground	-	Fig.1
	P-SIS connector	2 (low)	Chassis ground	-	Fig.1

G13666207

Courtesy of KIA MOTORS AMERICA, INC.

Good

Go to "COMPONENT INSPECTION " procedure.

No Good

Carefully re-do this troubleshooting guide steps.
If problem still occurs, replace SRSCM main harness and then go to "VERIFICATION OF REPAIR " procedure.