Malfunction Indicator Lamp (MIL): Non-EOBD
WARNING: This page is about a different variant/trim than selected.
A malfunction indicator lamp illuminates to notify the driver that there is a problem with the vehicle. However, the MIL will go off automatically after 3 subsequent sequential driving cycles without the same malfunction. Immediately after the ignition switch is turned on (ON position - do not start), the MIL will illuminate continuously to indicate that the MIL operates normally.
Faults with the following items will illuminate the MIL
- Heated oxygen sensor (HO2S)
- Manifold Absolute Pressure Sensor (MAPS)
- Throttle Position Sensor (TPS) [integrated into ETC Module]
- Water temperature sensor (WTS)
- ETC Motor [integrated into ETC Module]
- Injectors
- ECM
NOTE:
(Refer to "Inspection Chart For Diagnostic Trouble Codes 1.6L
" for more information).