DTC Information: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.

Item		Detecting Condition	Possible Cause
DTC Strategy	Case1	Rationality check at power-on condition	Poor connector connection Short or open in signal circuit Faulty HECU
DTC Strategy	Case2	Rationality check at fuel-cut condition
Enable Conditions	Case1	Engine speed is over 1800RPM APS is higher than 10% Engine clutch torque is over 30Nm Engaged gear (AT only, not required for MT) is higher than 2
Enable Conditions	Case2	Engine speed is between 1000 and 3500RPM Fuel system status is fuel cut-off
Threshold Value	Case1	Vehicle speed is 1 km/h (0.62 mph)
Threshold Value	Case2	Vehicle speed is lower than 2.5 km/h (1.55 mph)
Diagnostic Time	Case1	30s
Diagnostic Time	Case2	20s
MIL ON Condition		2 driving cycles