Inspect OCV - In (Bank1)
WARNING: This page is about a different variant/trim than selected.
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
OCV - In (Bank1) (component side) | 2 (power) | OCV - In (Bank1) (component side) | 1 (control) | Approx. 6.9 to 7.9Ω at 20°C (68°F) |
Good
- Go to "VERIFICATION OF REPAIR " procedure.
No Good
- Carefully re-do this troubleshooting guide steps.
- If no problems were found with the circuits or connectors, replace the OCV - In (Bank1) and go to "VERIFICATION OF REPAIR " procedure.