Component Inspection
WARNING: This page is about a different variant/trim than selected.
| Inspection Condition | (+) Probe | (-) Probe | Reference | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
FPCM connector (component side) | 1 (fuel sender | FPCM connector (component side) | 3 (fuel sender | Table1 |
FLS AND FUEL PUMP MOTOR SPECIFICATION
| Float Position | Sender Resistance (Ω) |
|---|---|
| E | 298 to 305 |
| 1/2 | 85.5 to 87.5 |
| F | 14 to 16 |
Good
- Go to "VERIFICATION OF REPAIR " procedure.
No Good
- Carefully re-do this troubleshooting guide steps.
- If no problems were found with the circuits or connectors, replace the FLS & fuel pump motor and go to "VERIFICATION OF REPAIR " procedure.