DTC Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
- Transition time monitor (rich to lean)
|
- Poor connector connection
- HO2S (Bank1, Sensor2)
- ECM
|
| Enable Conditions |
- Battery voltage is greater than 10.7V
- Engine speed is between 1200 and 3520RPM
- EGT around ROS (model) is greater than 425°C (797°F)
- Exhaust gas mass flow 6.12 kg/h
- Change amount of exhaust gas mass flow is between -150.12 and 150.12 kg/h
- Fuel system status is fuel cut-off
- ROS voltage is greater than 0.63V (before fuel cut-off)
|
| Threshold Value |
- Transition time (average) is greater than 0.70s
|
| Diagnostic Time |
- 2 valid fuel cut-off phases (once per driving cycle)
|
| MIL ON Condition |
|