Component Inspection
WARNING: This page is about a different variant/trim than selected.
| Inspection Condition | (+) Probe | (-) Probe | Reference | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
ECTS (component side) | 3 (signal) | ECTS (component side) | 1 (ground) | Table1 |
Resistance of ECTS
| Temperature [°C (°F)] | Resistance [kΩ] | Temperature [°C (°F)] | Resistance [kΩ] |
|---|---|---|---|
| -40 (-40) | 48.14 | 60 (140) | 0.59 |
| -20 (-4) | 14.13 to 16.83 | 80 (176) | .32 |
| 0 (32) | 5.79 | 100 (212) | 0.19 |
| 20 (68) | 2.31 to 2.59 | 110 (230) | 0.145 to 0.149 |
| 40 (104) | 1.15 | 120 (248) | 0.12 |
Good
- Go to "Verification of Repair " procedure.
No Good
- Carefully re-do this troubleshooting guide steps.
- If no problems were found with the circuits or connectors, replace the MAPS and go to "Verification of Repair " procedure.