Component Inspection
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
ECM component side (G 3.3 GDI LAMBDA II) | 77 (C-CAN High) | ECM component side (G 3.3 GDI LAMBDA II) | 60 (C-CAN Low) | Approx. 120Ω |
| Cluster component side | 32 (C-CAN High) | Cluster component side | 33 (C-CAN Low) | Approx. 120Ω | |
Good
- Carefully re-do this troubleshooting guide steps.
- If problem still occurs, replace control unit that causing the fault and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
No Good
- Carefully re-do this troubleshooting guide steps.
- If no problems were found with the circuits or connectors and DTC still occurs, replace the ECM or Cluster and go to "VERIFICATION OF REPAIR " procedure.
* In case of replacing control unit, perform necessary "Vehicle S/W Management".