Main harness Circuit Inspection

Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Ignition "OFF". Disconnect the battery (-) terminal cable from the battery and wait at least one minute. Disconnect PCAB connector and SRSCM main connector. 4) Ignition "ON".	PCAB connector	1 (high)	Chassis Ground	-	Fig.1
	PCAB connector	2 (low)	Chassis Ground	-	Fig.1

G00598921

Courtesy of KIA MOTORS AMERICA, INC.

Good

Carefully re-do this troubleshooting guide steps.
If problem still occurs, replace SRSCM and then go to "VERIFICATION OF REPAIR " procedure.

No Good

Carefully re-do this troubleshooting guide steps.
If problem still occurs, replace SRSCM main harness and then go to "VERIFICATION OF REPAIR " procedure.