Circuit Inspection
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
SCC (FCA) connector | 8 (C-CAN high) | Chassis ground | - | Fig.1 |
| SCC (FCA) connector | 7 (C-CAN low) | Chassis ground | - | ||
|
SCC (FCA) connector | 8 (C-CAN high) | Chassis ground | - | ∞ (infinity)Ω |
| SCC (FCA) connector | 7 (C-CAN low) | Chassis ground | - | ∞ (infinity)Ω | |
|
SCC (FCA) connector | 8 (C-CAN high) | MDPS connector | 7 (C-CAN high) | Approx. below 1Ω |
| SCC (FCA) connector | 7 (C-CAN low) | MDPS connector | 8 (C-CAN low) | Approx. below 1Ω | |
Good
- Check MDPS, SCC (FCA) Module connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "SYSTEM INSPECTION " procedure.
No Good
- Check for open/short in harness.
- Repair as necessary and then go to "VERIFICATION OF REPAIR " procedure.