Circuit Inspection
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
IBAU Connector | 1 (Memory power) | Chassis ground | - | B+ |
| 30 (Memory power) | - | B+ | |||
| 5 (ON/START input) | - | B+ | |||
| 14 (ground) | - | Approx. below 1Ω | |||
| 46 (ground) | - | Approx. below 1Ω | |||
|
IGPM Connector | 4 (C-CAN high) | IGPM Connector | 3 (C-CAN low) | Fig.1 |
Good
- Go to "C-CAN INSPECTION " procedure.
No Good
- Repair as necessary and then go to "VERIFICATION OF REPAIR " procedure.
C-CAN INSPECTION CONDITION
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
IBAU Connector | 38 (C-CAN high) | IBAU Connector | 39 (C-CAN low) | Approx. 60Ω |
| FCA unit connector | 8 (C-CAN high) | FCA unit connector | 7 (C-CAN low) | Approx. 60Ω | |
| IBAU Connector | 38 (C-CAN high) | FCA unit connector | 8 (C-CAN high) | Approx. below 1Ω | |
| IBAU Connector | 39 (C-CAN low) | FCA unit connector | 7 (C-CAN low) | Approx. below 1Ω | |
Good
- Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
- Repair or replace as necessary and then go to "VERIFICATION OF REPAIR " procedure.
No Good
- Carefully re-do this troubleshooting guide steps.
- If no problems were found with the circuits or connectors, replace FCA unit and then go to "VERIFICATION OF REPAIR " procedure.