| DTC Strategy |
- Brake fluid pressure monitoring
|
- Brake fluid leak
- Brake fluid pressure line sensor failure
|
| Enable Condition |
|
| Threshold Value |
- Failure is detected if the circuit pressure doesn't reach the target pressure and there is a pressure gap between right and left circuit
- Failure is detected if the HPA decreasing rate is greater than target pressure in brake fluid level low state with one of conditions below,
- The circuit pressure does not reach a certain range of target pressure.
- The circuit pressure fluctuates out of certain range.
- The circuit pressure is fixed during the control.
|
| Warning Lamp |
- EBD/RBS/ABS/ESC (ESP)/DBC/AVH warning indicator lamp "ON"
|
| Disable Condition |
- Ignition "OFF" and "ON", Normal pressure charging more than 3s
|