| DTC Strategy |
|
- Poor connector connection
- Large Air-Gap
- Faulty signal circuit of front-RH wheel speed sensor
- Faulty wheel speed sensor front-RH
|
| Enable Condition |
|
| Threshold Value |
Case1 |
- In case of large air gap between tone wheel and wheel speed sensor, there is no pulse signal input and ABS/ESC/ESP recognizes wheel speed as 0 km/h (0 MPH) A failure is detected by comparison of the 4 wheels speed in following conditions
- A failure is detected in case that the slowest wheel speed is below 0.25 km/h (0.1 MPH) and all other wheel speeds exceed 10 km/h (6.2 MPH) with the vehicle acceleration under 0.4G (14 km/h per 1s) and this condition continues 160 ms
- A failure is detected in case that two or more wheels speed is below 2 km/h (1.2 MPH) and the speed of other wheel(s) exceed 10 km/h (6.2 MPH) with the vehicle acceleration under 0.4G (14 km/h per 1s) and this condition continues 20s
- If the vehicle acceleration is above 0.4G (14 km/h per 1s) in 1), 2), the failure detection time 180s
- A failure is detected in case that one or two wheel speed is below 0.25 km/h (0.1 MPH) longer than 12s after all wheels exceed 10 km/h (6.2 MPH). However, If All Non-dive wheel are less than 0.25 km/h (0.1 MPH), fault detection time is 120s
|
| Case2 |
- A failure is detected if the wheel speed is below 2 km/h (1.2 MPH) longer than 12s during ABS control
- A failure is detected if the ABS control duration exceeds 36s. In this case, ABS/ESC/ESP recognizes all wheels are defective
- A failure is detected if the wheel speed is above 512 km/h (318 MPH) longer than 100 ms
|
| Warning Lamp |
- ABS/ESC (ESP)/AVH Warning Indicator Lamp "ON"
- In case of failure on more than two wheels
- EBD Warning Indicator Lamp "ON" (Inhibits EBD)
- In case of failure on all wheels
- Brake (EBD) Warning Indicator Lamp "ON" (AHB performance degradation)
|
| Disable Condition |
- Ignition "OFF" and then "ON" and Normal signal
|