Main Harness Circuit Inspection

Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Ignition "OFF". Disconnect the battery (-) terminal cable from the battery and wait at least one minute. Disconnect PCAB connector and SRSCM main connector.	PCAB connector	1 (high)	SRSCM connector	22 (high)	Approx. below 1Ω
	PCAB connector	2 (low)	SRSCM connector	21 (low)	Approx. below 1Ω

Good

Carefully re-do this troubleshooting guide steps.
If problem still occurs, replace SRSCM and then go to "VERIFICATION OF REPAIR " procedure.

No Good

Carefully re-do this troubleshooting guide steps.
If problem still occurs, replace SRSCM main harness and then go to "VERIFICATION OF REPAIR " procedure.