LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2020 >> Soul GT Line Turbo >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Engine And Transmission Assembly (R & I) - 1.6L >> Engine And Transmission Assembly >> Repair Procedures >> Installation

Repair Procedures: Installation

  1. Installation is in the reverse order of removal.
  2. Refill with the engine oil.

    (Refer to Lubrication System - "ENGINE OIL ")

  3. Refill the radiator with coolant.

    (Refer to Cooling System - "COOLANT ")

    Perform the following

    • Adjust shift cable
    • Refill transaxle with transaxle fluid.
    • Inspect for fuel leakage.
      • After assemble the fuel line, turn on the ignition switch (do not operate the starter) so that the fuel pump runs for approximately two seconds and fuel line pressurizes.
      • Repeat this operation two or three times, then check for fuel leakage at any point in the fuel line.
    • Clean battery posts and cable terminals with sandpaper assemble them, then apply grease to prevent corrosion.
scientia non olet · About LEMON Manuals