Circuit Inspection

Courtesy of KIA MOTORS AMERICA, INC.

Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Disconnect the electrical connector(s) from the concerned component. Ignition "ON".	TCM connector	17, 65, 66 (power)	Chassis ground	-	B+
Ignition "OFF". Disconnect the electrical connector(s) from the concerned component.	TCM connector	57, 58, 61 (ground)	Chassis ground	-	Approx. below 1Ω

Good

Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
Carefully re-do this troubleshooting guide steps.
If problem still occurs, replace TCM and then go to "Verification of Repair " procedure.

No Good

Carefully re-do this troubleshooting guide steps.
Check the related "FUSE". Check for open/short in harness. Repair as necessary and go to "Verification of Repair " procedure.