DTC Inspection: DTC Detecting Condition

Item	Detecting Condition	Possible Cause
DTC Strategy	There is enough force on shift motor2 but not enough motion of gear actuator finger is detected while disengaging 2nd gear	Faulty gear shift assembly Faulty DCT Mechanical failure on gear2 shift direction
Enable Condition	When 2nd gear is disengaged Battery voltage higher than 10V Shift motor2 voltage higher than 9V No electrical failure on shift motor2
Threshold Value	Shift motor2 force higher than 900N Shift motor2 motion less than 0.1419mm
Fail Safe	Drive at odd gear
Detecting Time	3 events
MIL ON Condition	2 driving cycles