| DTC Strategy |
- There is enough force on shift motor1 but not enough motion of gear actuator finger is detected while disengaging 1st gear
|
- Faulty gear shift assembly
- Faulty DCT
- Mechanical failure on gear1 shift direction
|
| Enable Condition |
- When 1st gear is disengaged
- Battery voltage higher than 10V
- Shift motor1 voltage higher than 9V
- No electrical failure on shift motor1
|
| Threshold Value |
- Shift motor1 force higher than 900N
- Shift motor1 motion less than 0.1419mm
|
| Fail Safe |
|
| Detecting Time |
|
| MIL ON Condition |
|