LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2020 >> Soul GT Line Turbo >> Repair and Diagnosis >> Suspension >> Wheels & Tire System >> TPMS Diagnosis >> DTC C1642-00: CAN Message Failure - Brake >> DTC Inspection >> Monitor KDS Data

Monitor KDS Data

Inspection Condition Inspection Procedure Reference
  1. Engine "ON".
  2. Vehicle driving.
  1. Connect KDS to "Data Link Connector (DLC)".
  2. Select HECU system.
  3. Monitor parameters in "Current Data" with KDS.
 Fig.1
G13288925Courtesy of KIA MOTORS AMERICA, INC.

Good 

  1. Fault is intermittent caused by poor contact in the sensor's and/or HECU connector or was repaired and HECU memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
  2. Repair or replace as necessary and go to "Verification of Repair " procedure.

No Good 

  1. Go to "Wiring Inspection " procedure.
scientia non olet · About LEMON Manuals