Circuit Inspection

G13284758

Courtesy of KIA MOTORS AMERICA, INC.

Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Ignition "OFF". Disconnect the battery (-) terminal cable from the battery, and wait at least one minute. Disconnect PFIS connector and SRSCM main connector.	PFIS connector	1 (high)	SRSCM connector	32 (high)	Approx. below 1Ω
	PFIS connector	2 (low)	SRSCM connector	31 (low)	Approx. below 1Ω
	PFIS connector	1 (high)	Chassis ground	-	∞ (infinity)Ω
	PFIS connector	2 (low)	Chassis ground	-	∞ (infinity)Ω
Ignition "OFF". Disconnect the battery (-) cable and wait at least for one minute. Disconnect PFIS connector. Connect the battery (-) terminal cable. Ignition "ON".	PFIS connector	1 (high)	Chassis ground	-	Fig.1
	PFIS connector	2 (low)	Chassis ground	-	Fig.1

G13284759

Courtesy of KIA MOTORS AMERICA, INC.

Good

Go to "Component Inspection " procedure.

No Good

Carefully re-do this troubleshooting guide steps.
If problem still occurs, replace SRSCM main harness and then go to "Verification of Repair " procedure.