Inspection Procedure

Check fuses and relays.
Check battery terminals and charge status.
Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
Good
1. Go to "Circuit Inspection " procedure.
No Good
1. Repair as necessary and then go to "Verification of Repair " procedure.

G13284577

Courtesy of KIA MOTORS AMERICA, INC.

Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Ignition "OFF". Disconnect the electrical connector(s) from the concerned component. Ignition "ON".	Passenger temperature actuator connector	5 (power)	Chassis ground	-	5V
Ignition "OFF". Disconnect battery (-) cable. Disconnect the electrical connector(s) from the concerned component.	Passenger temperature actuator connector	7 (ground)	Chassis ground	-	Approx. below 1Ω
Ignition "OFF". Disconnect the electrical connector(s) from the concerned component and A/C control module.	Passenger temperature actuator connector	6 (feedback)	A/C control module (auto) connector	1 (feedback)	Approx. below 1Ω
	Passenger temperature actuator connector	6 (feedback)	Chassis ground	-	∞ (infinity)Ω

Good

Go to "Component Inspection " procedure.

No Good

Repair open or short in circuit and then go to "Verification of Repair " procedure.