Heater Pipe

WARNING: This page is about a different variant/trim than selected.

Remove the intake manifold.
(Refer to Intake and Exhaust System - "INTAKE MANIFOLD ")
Remove the bypass hose (A).
Loosen the heater pipe mounting bolts and then remove the heater pipe & hoses (B).
Tightening torque:

19.6 - 23.5 N.m (2.0 - 2.4 kgf.m, 14.5 - 17.4 lb.ft)

Courtesy of KIA MOTORS AMERICA, INC.

NOTE: Always use a new seal bolts.
Install in the reverse order of removal.
Fill the engine coolant.
(Refer to Cooling System - "COOLANT ")
Start the engine and check for leaks.
Recheck the coolant level.