DTC P2422-00: Evaporative Emission System Vent Valve Stuck Closed: General Description

The Canister Close Valve (CCV) is located on the EVAP canister and is used to seal the canister vent. The CCV responds to signals from the PCM. When the PCM sends an ON signal, the coil in the solenoid valve is energized. A plunger will then move to seal the canister vent. The ability to seal the vent is necessary for the on board diagnosis of other evaporative emission control system components. The CCV is used only for diagnosis, and usually remains opened. When the vent is closed, under normal purge conditions, the evaporative emission control system is depressurized and allows EVAP control system (small leak) diagnosis.