Component Inspection

WARNING: This page is about a different variant/trim than selected.

Inspection Condition	Inspection Procedure	Reference
Ignition "ON". Engine "ON" and no DTC.	Connect KDS to "Data Link Connector (DLC)". Perform "Actuation Test" of concerned component with KDS.	Fig.1

G13292335

Courtesy of KIA MOTORS AMERICA, INC.

Inspection Condition	(+) Probe		(-) Probe		Reference
Inspection Condition	Connector	Terminal	Connector	Terminal	Reference
Engine "ON".	Injector #4 connector	2 (power)	Chassis ground	-	Fig.2
Engine "ON".	Injector #4 connector	1 (control)	Chassis ground	-	Fig.2

G13292336

Courtesy of KIA MOTORS AMERICA, INC.

Good

Go to "Verification of Repair " procedure.

No Good

Carefully re-do this troubleshooting guide steps.
If no problems were found with the circuits or connectors, replace the injector#4 and go to "Verification of Repair " procedure.