Inspection Procedure
WARNING: This page is about a different variant/trim than selected.
- Refer to appropriate service information and visually and/or physically inspect following conditions:
- Check EVAP canister for fuel saturation. If the EVAP canister is full of fuel, inspect EVAP and fuel system.
- Remove the manifold side vacuum hose from the EVAP canister purge valve.
- Using a hand vacuum pump, apply specified vacuum to the manifold side of the valve.
- Has any problems been found?
Good
- Go to "Fuel System Inspection " procedure.
No Good
- Repair as necessary and than go to "Verification of Repair " procedure.